- power up board
- connect to MW GUI
- make sure that the altitude readings from the baro sensor have stabilized in the graph
- make any change (such as an AUX checkbox) and write the changes to EEPROM - the readings will appear to pause for about half a second as the EEPROM write takes place.
- observe if the altitude readings on the graph experience a noticeable shift after the EEPROM write completes.
I'm trying to determine if this is a programming defect/side-effect, or if there's actually a voltage drop/spike on the board due to the EEPROM write that causes a glitch in the MS5611 BARO sensor readings. Please help, I'd really appreciate it.