Accelerometer position on frame
Posted: Tue Dec 03, 2013 2:23 pm
Hi,
my sensor (MPU6050) is about 2-3cm from the middle of the centerplate.
It was my first copter and I thought that it doesn't make any differences: The measured angle will be same - but now I realised that the angular speed will be different.
Does it influence the calulaction badly or is it not so bad? (Is there any parameter to tune the position of the accelerometer?)
Thanx in advance
derget
my sensor (MPU6050) is about 2-3cm from the middle of the centerplate.
It was my first copter and I thought that it doesn't make any differences: The measured angle will be same - but now I realised that the angular speed will be different.
Does it influence the calulaction badly or is it not so bad? (Is there any parameter to tune the position of the accelerometer?)
Thanx in advance
derget