Page 1 of 1
Crius SE 2.0 programming with Arduino nano
Posted: Wed Nov 27, 2013 11:49 am
by biedronas
HI!
I bought Crius SE v2.0 from rctimer. I have also arduino nano, but i don't have FTDI adapter. Can I use Arduino as a ISP programmer to set my board? How to do this?
Re: Crius SE 2.0 programming with Arduino nano
Posted: Sat Nov 30, 2013 8:36 am
by o_lampe
Yes, just short the reset pin with GND on the Nano board and you have an FTDI-Adapter.
Connect the RX with RX and TX with TX.
Re: Crius SE 2.0 programming with Arduino nano
Posted: Thu Dec 05, 2013 4:22 pm
by biedronas
I find picture how to connect arduino to use it as a ftdi programmer, but when i tried to do something I get error avrdude: stk500_getsync(): not in sync: resp=0x00. I tried to solve it and I failed.
I have rs232 port in my computer and lpt port. Does anyone know, if I can use them to program multiwii and use Multiwii Configurator?
Re: Crius SE 2.0 programming with Arduino nano
Posted: Tue Feb 25, 2014 1:57 pm
by txdo_msk
You can use either method AFAIK. You just need to find the serial pinout to use to connect your arduino to computer.
I believe you would be best served by shorting reset and ground with a small capacitor.