Is my Multiwii pro FC faulty?
Posted: Sat Nov 09, 2013 4:05 am
I bought a MultiWii Pro (ATMega 2560) from HobbyKing recently. Immediately after opening the box, I installed the drivers on my computer, as well as the MultiWii GUI and Arduino. I loaded some code from another guy (link below) and then opened the GUI to connect to my board. When I connect, the paramaters tab shows the correct paramaters, which I can change and save to the board. However, when I go to the "Real Time Data" tab, the lines are at 0 even when I move the board around. So it seems that the sensors are not working. There are no I2C errors and the GUI is receiving packets from the board. Any ideas? Thanks
Here's the instructions and code I'm using: http://www.youtube.com/watch?v=dW1VF8eS4Ac
Here's the instructions and code I'm using: http://www.youtube.com/watch?v=dW1VF8eS4Ac