HK MultiWii 328P Flight Controller w/FTDI & DSM2 Port

[Nickman1200]

As I didn't find a dedicated thread about this board in this forum here we go.

This is sold by Hobby King: MultiWii_328P_Flight_Controller_w_FTDI_DSM2_Port

In config.h from MultiWii v2.2 and newer choose:
#define HK_MultiWii_328P
also
#define RCAUXPIN12 (seen in the pricture below)

One thing I found out today was that if you want to connect a Blutooth module you can use AX2, AX3 and then you don't even have to solder any pins.
Another advantage of using AX2 instead of the middle pin on JP1 is that you can leave the strap on USB enable.

I made a picture from all information I could find on the internet.
Maybe it's of use to someone more then me. (Which I had it when i got my card)


Uploaded with ImageShack.us

[emes]

There's ISP interface too:

[handsomejackuk]

can anyone give me some further information on how to use ax2, ax3 for bluetooth connection please...

thanks Alun

[Nickman1200]

can anyone give me some further information on how to use ax2, ax3 for bluetooth connection please...

thanks Alun

Just look at the picture above. All information is there

Connect:
TX on the BT module to RXI (AX2)
RX on the BT module to TX0 (AX3)
GND to GND on either AX3 or AX2
VCC to VCC on either AX3 or AX2

Here is a picture just in case

[handsomejackuk]

got that thanks i will try that setup for now i want to try and get the oled display to work too...

[handsomejackuk]

sorted that one thanks.... got to say i would never have worked that out... done the first multiwii 2.2 sketch upload too....

just need to get the oleg working now....!!!

[ACME Milli-Rotor]

Wow nice pin chart I'll now I know were to look when I want to add BT, Thanks

[Villalji]

Hi! Im new in this Forum but not so much to multiwii last year I succesfully flown a tricopter using this board, and now I want to upgrade it with BT and GPSbut I do not know how to connect them at the same time. I have this BT module:
http://rover.ebay.com/rover/0/e11400.m1842.l5919/7?euid=428e7d3388bf40cbaf51704f206d5bd8&loc=http%3A%2F%2Fpayments.ebay.de%2Fws%2FeBayISAPI.dll%3FViewPaymentStatus%26transId%3D1696913344016%26itemId%3D262019619370%26qu%3D1
And this GPS:
http://rover.ebay.com/rover/0/e11400.m1842.l5919/7?euid=8d8e50d3590a477f97680b440c717bcc&loc=http%3A%2F%2Fpayments.ebay.de%2Fws%2FeBayISAPI.dll%3FViewPaymentStatus%26transId%3D1535869740017%26itemId%3D271860471415%26qu%3D1
Could you show in the board diagram how to connect them?

Thank a bunch!