Are CAM1, CAM2 and A2 PWM-Outputs?

[Amigorodrigo]

Hi guys!

Just ordered the new board from here...
http://www.multiwiicopter.com/products/ ... board-v2-0
...and there are additional connectors "The main difference to the warthox board is the addition of 3 outputs A0(camera1), A1(Camera2) and A2(for future Alex software upgrades) "
A0...A2 are AnalogInputs - did Alex manage to get PWM-Signals out of these to connect additional Servos?!

btw.
@Alex: Awesome Job starting this great project!!! THX

[Alexinparis]

Yes,
It's possible to drive a servo from any free PINs, analogical or digital.
a cam trigger option is coming

[Amigorodrigo]

Nice!

So if you have a sum-signal-receiver - you can use the "official" PWM-Outputs: 3,5,6,9,10,11 for a Y6-Setup and have servos for the cam as well on Cam1 and Cam2!?

[Alexinparis]

It would be nice, but there is an exception for HEX6 or Y6.
No servo can be driven with these setups, because all the timers are taken to drive the 6 motors.

For other 3 or 4 setups, yes there is no more servo limitations.
It should be possible to activate tilt ROLL+PITCH +cam trigger

[Amigorodrigo]

What a shame

So the real advantage is that you can use a standard receiver plus servos for camera-stabilization?

[Alexinparis]

Maybe a suggestion:
You could use 2 multiwii boards + 1 PPM SUM receiver.
- 1 board for Y6 with 4 or 5 channels
- the other one for cam with the remaining channels

Or switching to a seeeduino MEGA...