In 2008 I made a design of the first Qynx PCB.
This board was one of the first with a ITG3200 gyro. Equipped with a 3A switching power supply for the gimbal servos.
PCBs are manufactured by a Dutch company.
Software is also designed for extreme weather conditions.
Qynx 2
Since I do not have enough time available for writing the GPS and attitude hold software I have been thinking about my new
Qynx 2 board make available for open source with Multiwii software.
In my own (Qynx 1) software are all parameters via the Gui set. nothing needs to be programmed or compiled.
Maybe an idea to integrate something like this into the Multiwii software.
Mainboard Dimension 40x50mm with separate sensor board with Gyro / Accelerometer and magnetic compass.
Sensor Gel damped and a decent (prototype) housing.
Is there interest in Qynx2 make open hardware?
some pictures for information:
Best regards,
Rob Keij
