Put my new Flyduino in a tri frame i had and the Flyduino is dead because its getting no power. I followed Alex's mega instructions and the problem is the servo is on pin 2 and the flyduino uses that pin to get power so it expects an ESC on that pin to power the FC, so i need the servo on pin 3 and rear motor on pin 2. i could power the board direct from the lipo but that means removing a soldered jumper and running an extra wire from the power supply and i really dont want to do that or i could jumper the center pin between 2 and 3 and the ESC on 3 would then power the board umm! again i'm not really keen on that idea incase i want to swap the board out at some time. There must be an easy way round this, if you can think of it please share.
Ray
