Page 1 of 1
GPS uBlox NEO-6M CN-06 v2 hard reset?
Posted: Tue Oct 09, 2012 9:45 pm
by stuckinthemud
I've got a CN-06 GPS that isn't responding to external commands or outputting anything intelligible.
Anyone know how to force a hard reset of the unit, returning it to factory settings?
I've several units, so I know it's the GPS at fault, not the interface etc.
Jim
Re: GPS uBlox NEO-6M CN-06 v2 hard reset?
Posted: Wed Oct 10, 2012 10:14 pm
by miniquad
The v2 module has a built-in EEPROM chip to permanently store your configuration, which will make it a bit difficult to reset to default/factory settings. For v1 draining the battery out would reset the module to default. Have you tried the u-center software and to connect to the module using different baudrates starting from 9600 using a usb to serial adapter? If you are successful to connect, you can reconfigure the module.
U-Center download:
http://www.u-blox.de/en/evaluation-tool ... enter.html
Re: GPS uBlox NEO-6M CN-06 v2 hard reset?
Posted: Wed Oct 10, 2012 11:23 pm
by stuckinthemud
The u-center software won't communicate with it at any baud rate
Data is definitely being sent - RX LED on my serial interface shows plenty of activity.
Re: GPS uBlox NEO-6M CN-06 v2 hard reset?
Posted: Thu Oct 18, 2012 10:56 pm
by kataventos
Is your GPS green light flickering?
Is this what´s happening to you?
viewtopic.php?f=6&t=2499