I bought all this hardware quite some time ago and just getting around to connecting it all up.
Paris Aerial Photo v 3.0 board
Arduino pro mini
ATAVRSBIN1
Get Em LLC
I think the LLC board has the I2C pullups on both the 5v and 3.3 volt side
was able to compile and load version 2.1 MultiWii
When I run the GUI and start the display I get IC fault that counts up and rolls over and flat line on the display
I dont have a receiver connected not sure if thats a factor... also have not been able to get a good copy of the stick position pdf for some reason.
would appreciate some help on this setup
this is my third setup for copter control
have an old KK controller and also a multiwii with WMP flying as well