Hi,
As said before,I am using Bob's super simple shield.. But on my shield..am not getting 3.3v or 3v3 I bought the 3v3 especially for my sparkfun sensor.
What to do now?
Here's a video of it- JUST UPLOADED FOR THIS FORUM POST
https://www.youtube.com/watch?v=ONq0lQF ... ature=plcp
-Rahul
Not getting 3v3 on my shield. What to do now?
-
- Posts: 34
- Joined: Thu Aug 02, 2012 2:12 pm
Re: Not getting 3v3 on my shield. What to do now?
Did you solder across the bridge on the shield, if not you wont get 3.3v, if you did solder and not getting 3.3v then I would suspect your 3.3v reg is either in the wrong way round or it has failed. Remove pro mini and apply 5V to the board and measure output of 3.3v reg, http://bobsquads.com/shieldsmultiwii/su ... hield.html use the diagram under Overview to see what leg gives what reading.