MultiWii

This may have been asked before, but can someone confirm if I need the hardware pullups enabled?

I have a paris v4 board, with the following:

WM+ powered on the "pin12" pin.
BMA180 powered by 3v3
HMC5883 powered by 3v3
BMP085 powered by 3v3

Running the latest dev version of software. Everything seems ok in the gui, but i would like to make sure i`m not going to kill something. Posted this on another forum and someone said since V2 of the software I need to run the WM+ on the +5v line?

Cheers


Iain

Measured my I2C data lines and they are running at the correct voltage Just trying to find out why my quad took off like a rocket the other day - havent had time to check it again since, my wounds have just about mended - still got plasters on.

Can someone confirm the mention in the other forum about the voltage supply for the WM+ not needing to be supplied by d12 anymore and is ok straight from the +5v line?

Cheers

Iain

HI!

On my Paris V4 I have it connected to 3V3

Using genuine WMP and NK

NK connects to WMP

//UndCon