Crius Multwii Board Lite Problem

[zarkon]

Hi,

I recently bought one of those lite version, but at full throttle it just jumping and not flying. Throttle range are all set I even try to limit the range in multiwii config still the same, I have try 1.9,2.0pre1 and 2.0pre2 non of them works

Video

http://www.youtube.com/watch?feature=pl ... R1iFbNPrjQ

any idea what could be the cause ?

[Alexinparis]

When armed, all motors should run except if you checked MOTOR_STOP, is it the case ?

[zarkon]

When armed, all motors should run except if you checked MOTOR_STOP, is it the case ?

nope I set my min throttle to 980 for esc on that video but later I changed it to 1120 as I always forgot if it is armed or disarm , I can't figure out the behavior need more test but I don't know where to start debuging

[jevermeister]

A collegue of mine gave me his Crius Lite a few moments after you connect the board the blue LED is starting to blink fast and you cannot read anything from the board, you have to wait a couple of minutes to try again.

Freezing spray doesnt help.
What does the blue LED indicate?

Nils