Pro Micro board

[ronco]

Hi,

this is my fisrt eagle project

i trie to design a board for the Pro Micro.
i did not build it till now but i will do it soon.

print it with 150dpi

what do you think?

regards

felix

[Gartenflieger]

Nice job, ronco!

Thanks for sharing. If I wouldn't have a bunch of Prominis lying around, I would go for it right away.

Some people would maybe not have connected all the + from the ESCs together. For myself it has always worked this way, but others suspect there might be interference between the voltage regulators. Of course, they can always disconnect the +...

Regards
Christoph

[ronco]

hi,

[quote=Gartenflieger]Of course, they can always disconnect the +...[/quote]
i think so .. and its better to cut the + in the esc wire then on the pcb because every channel can be a servo.

i changed it a little to make it saver
i also buid the first one with this method http://thomaspfeifer.net/direct_toner_pcb.htm


regards felix

[ronco]

hi,

i made the next version .. its smaller and without bridges

a WMP dont fittes well but i wont make it bigger just for it..

i still cant belive that this workes with such a simple method