Crius SE 2.0 programming with Arduino nano

[biedronas]

HI!
I bought Crius SE v2.0 from rctimer. I have also arduino nano, but i don't have FTDI adapter. Can I use Arduino as a ISP programmer to set my board? How to do this?

[o_lampe]

Yes, just short the reset pin with GND on the Nano board and you have an FTDI-Adapter.
Connect the RX with RX and TX with TX.

[biedronas]

I find picture how to connect arduino to use it as a ftdi programmer, but when i tried to do something I get error avrdude: stk500_getsync(): not in sync: resp=0x00. I tried to solve it and I failed.
I have rs232 port in my computer and lpt port. Does anyone know, if I can use them to program multiwii and use Multiwii Configurator?

[txdo_msk]

You can use either method AFAIK. You just need to find the serial pinout to use to connect your arduino to computer.

I believe you would be best served by shorting reset and ground with a small capacitor.