Arduino Pro Mini + WMP + AM3X Analog Accelerometer

[Habanero000]

Hi Folks, I need some help here.

I am trying to connect my Analog Accelerometer, Freetronics AM3X which I believe is the same as the Sparkfun ADXL335, to my WMP controller. BTW, the AM3X does not have SCL/SDA output

I don’t want to use the AM3X output to the Pro Mini analog inputs. I am hoping to use the WMP ADC to get the accelerometer into the I2C signal.

I’m sure I’ve seen inputs points on the WMP board to accept the X, Y, Z analog outputs from the AM3X, but my laptop battery ran dry and I didn’t have the URL.

AM3X XYZ Analog Output --> WMP Analog Input --> I2C --> Arduino Pro Mini

Any help would be appreciated.

[ktuluz]

How did u go getting this to work?


I have the same setup , about to look into setting it up