Page 1 of 1
MW OSD R1.3 Trouble Writing Settings
Posted: Wed Mar 18, 2015 1:26 pm
by rsshepard
I have been running MW OSD 1.2 for a little while now and decided to try 1.3. I didn't have any trouble flashing the firmware. I was able to connect to the GUI( very nice upgrades by the way) and I can upload the font. I can read from the board but I can't write to it. My FTDI shows red and green flashing lights and I get the message that it is attempting to write 20 times but no joy. I rolled back to 1.2 without any issues. Anyone else have this issue?
Re: MW OSD R1.3 Trouble Writing Settings
Posted: Thu Mar 26, 2015 2:36 pm
by Hifly
Got the same problems on a couple of MavLink 2.0 and 2.1 with 5v mod. Just bought a new MavLink to do some workbench testing. Hope to find some time soon to do the testing.
Re: MW OSD R1.3 Trouble Writing Settings
Posted: Mon Apr 06, 2015 4:18 pm
by corocrumpler
I ran into the same problem... To get around it I change just one entry at a time and write it to the OSD.
Re: MW OSD R1.3 Trouble Writing Settings
Posted: Mon May 11, 2015 1:41 pm
by cururu
Try to clear the EEprom of MinimOSd before uploading a new firmware, maybe thats because when you roll it back do 1.2 it works.
Arduino - Examples - Clear_EEPROM
Upload to MinimOSD
Try uploading MW OSD 1.3 again.
Re: MW OSD R1.3 Trouble Writing Settings
Posted: Fri May 15, 2015 5:41 am
by Arakon
Known issue. Grab the 1.4 beta off the mwosd page, it will be fixed there.