MW OSD R1.3 Trouble Writing Settings

Post Reply
rsshepard
Posts: 2
Joined: Wed Mar 18, 2015 1:16 pm

MW OSD R1.3 Trouble Writing Settings

Post by rsshepard »

I have been running MW OSD 1.2 for a little while now and decided to try 1.3. I didn't have any trouble flashing the firmware. I was able to connect to the GUI( very nice upgrades by the way) and I can upload the font. I can read from the board but I can't write to it. My FTDI shows red and green flashing lights and I get the message that it is attempting to write 20 times but no joy. I rolled back to 1.2 without any issues. Anyone else have this issue?

Hifly
Posts: 3
Joined: Tue Jan 13, 2015 9:06 pm

Re: MW OSD R1.3 Trouble Writing Settings

Post by Hifly »

Got the same problems on a couple of MavLink 2.0 and 2.1 with 5v mod. Just bought a new MavLink to do some workbench testing. Hope to find some time soon to do the testing.

corocrumpler
Posts: 1
Joined: Mon Apr 06, 2015 3:43 pm

Re: MW OSD R1.3 Trouble Writing Settings

Post by corocrumpler »

I ran into the same problem... To get around it I change just one entry at a time and write it to the OSD.

cururu
Posts: 5
Joined: Thu Jan 10, 2013 3:21 pm

Re: MW OSD R1.3 Trouble Writing Settings

Post by cururu »

Try to clear the EEprom of MinimOSd before uploading a new firmware, maybe thats because when you roll it back do 1.2 it works.

Arduino - Examples - Clear_EEPROM

Upload to MinimOSD

Try uploading MW OSD 1.3 again.

Arakon
Posts: 196
Joined: Thu Jul 17, 2014 2:22 pm

Re: MW OSD R1.3 Trouble Writing Settings

Post by Arakon »

Known issue. Grab the 1.4 beta off the mwosd page, it will be fixed there.

Post Reply