I currently have a Multiwii board up and running with GPS and 3dr Telemetry Radio. My GPS is connected to UART2 and my 3dr Link is connected in series with the USB/Serial UART0. I will be receiving my MinimosD tomorrow and im looking for a bit of guidance. I have searched the interwebs and haven't found a clear answer.
DISCLAIMER :I have not done any experimenting! Some say connect the MinimOSD to the UART0 , others say "the bluetooth port" which i assume they are referring to one of the other UARTS. My question is, if i connect the MinimOSD in parallel with the 3dr Radio and dont have a connection established with my laptop will the MulitWii UART naturally (without request) dump the data out for the OSD. I wouldn't imagine id want both the OSD and 3dr Radios TX pins to be tied together and to the Multiwii.
Can i simply configure(just set the port speed right?) one of the other UARTS and connect the OSD it?
I'm not afraid to mess with configs. I would just like some guidance before i go in blindly.
FC:
http://witespyquad.gostorego.com/flight ... oller.html
MinimOSD
http://witespyquad.gostorego.com/minimosd.html
MinimOSD w/ KV v1.0 VIA MultiWii PRO 2.0
-
- Posts: 2
- Joined: Thu Jun 12, 2014 12:59 pm
Re: MinimOSD w/ KV v1.0 VIA MultiWii PRO 2.0
Nothing? Perhaps there is a better place to ask this question. Anyone care to direct me there?
Re: MinimOSD w/ KV v1.0 VIA MultiWii PRO 2.0
You can connect the Osd to any of the serials.
Just make sure serial speed is set to match.
Just make sure serial speed is set to match.
-
- Posts: 1
- Joined: Mon Aug 03, 2015 2:25 pm
MinimOSD w/ KV v1 0 VIA MultiWii PRO 2 0
I havent tried via USB yet, but music plays fine using google play on my s6 via bluetooth.
You did select the device from the "Media" menu right?
You did select the device from the "Media" menu right?