one shot and disconnecting motors
Posted: Tue May 19, 2015 11:48 am
Two questions here maybe someone that rights the code will know..
why do we have to disconnect the escs before enabling / disabling one shot in the gui ?
and the next sort of related but i have disconnected the escs and they still dont work.
I have flashed simonk software all be it an earlier release back on to my afro escs. (I did briefly try blheli but found it to be very sluggish).
Running dys 1806 motors and as i have mentioned afro 12a escs naze 32 cleanflight v 1.8...
my escs no longer appear to work on oneshot if i slide the motor sliders up on the gui no motors spin, disable oneshot, and they work again i am beginning to wonder whether the simonk version 2014-09-30 maybe doesnt support one shot
any thoughts on this ?
why do we have to disconnect the escs before enabling / disabling one shot in the gui ?
and the next sort of related but i have disconnected the escs and they still dont work.
I have flashed simonk software all be it an earlier release back on to my afro escs. (I did briefly try blheli but found it to be very sluggish).
Running dys 1806 motors and as i have mentioned afro 12a escs naze 32 cleanflight v 1.8...
my escs no longer appear to work on oneshot if i slide the motor sliders up on the gui no motors spin, disable oneshot, and they work again i am beginning to wonder whether the simonk version 2014-09-30 maybe doesnt support one shot
any thoughts on this ?