Hi everyone,
I am currently trying to install a Multiwii Pro into my plane, which looks fine so far.
But when i arm, the servo-output does not work.
The GUI shows "Arm" and the bars on the top-right indicate servo movement, but there is none.
Neither output port moves a servo, what did I do wrong?
I didnt changed much in the config besides setting it to Airplane and enabling flaps.
Armed but no effect
Re: Armed but no effect
just a wild guess, are you using the right motor outputs ? maybe have a look at the config servo settings
-
- Posts: 2
- Joined: Sat Aug 16, 2014 12:32 am
Re: Armed but no effect
What exactly do you mean? PInwise?
I checked it on all output pins, there is no pin that updates the servo. Sadly I don't have a Oszilloscope to verify that.
In the config I changed nothing regards servos.
I checked it on all output pins, there is no pin that updates the servo. Sadly I don't have a Oszilloscope to verify that.
In the config I changed nothing regards servos.
Re: Armed but no effect
Do the servo ports you are using have power?