I have a receiver controlled switch that I had connected to channel 7 of my RX before I started using CPPM (http://www.hobbyking.co.uk/hobbyking/st ... oduct=8833). What is the best way to get this working while using CPPM? I've read about enabling SERVO_TILT and setting gimbal_flags=4.
Thanks
Acro Naze32, CPPM, and receiver controlled switch
Re: Acro Naze32, CPPM, and receiver controlled switch
its likely you can still use your rx normal output pins as well, but otherwise here is how to pass through a rx channel: viewtopic.php?f=18&t=5417#p54208