I'm trying to flash the firmware on my storm 32 gimbal controller. I have an FTDI board plugged in to do this. Problem is that when I hit the flash firmware button, the dos box that comes up says ERROR: cannot open the com port, it may be in use by another application. I tried switching it to a different com port but no success. Can anybody give me some suggestions on what the issued might be?
Thanks
Storm 32 board on a gimbal help
Storm 32 board on a gimbal help
Last edited by rsbkh on Mon Feb 15, 2016 3:18 pm, edited 1 time in total.
Re: Storm 32 board on a gimbal help
So it turns out the chip on my FTDI board was bricked by the latest Windows drivers. So I reprogrammed the eeprom with the proper VID and then downloaded some older drivers. Then I installed the serial converter driver, unplugged it, plugged it back in and it came up under the com port. I installed the com port driver and then it worked. Wow! What a pain! All that just so I could update the firmware on the gimbal and be able to calibrate it.