Octocopter with Flyduino MW32 V2

[Zt3Ph3N]

Hi there,

I'm planning to build an Octocopter with FC MW32 V2 from Flyduino. There is one problem for me now. I need to set the mixer to octox8 for example, but I don't know where to connect the Motors for this Setup. The Manual from Flyduino is useless for octos.
What do I have to do, to get this to work?

Thanks for your help.

Greetings
Stephen

[timecop]

Cloners not writing proper manuals, what a shock?
You will need PPM receiver (obviously), with feature PPM enabled, when you set octo mixer, first 6 motors are off the usual motor pins, and the last 2 are from the RC5, RC6 pins.

[Zt3Ph3N]

The MW32 is a clone of the Naze32, right? Then I buy this one. But I've read that manual too, and found no Info for Octos.

I've got a Graupner MX-16 Control-Set.

Receiverpinnings on the Board (MW32 currently):
The Pins 1 - 4 for the Controls
Pin 5 - Motor 7
Pin 6 - Motor 8
Pin 7 - Aux
Pin 8 - Aux

Do I understand that correctly?

Greetings
Stephen

[timecop]

You *need* a PPM receiver for octo. If you don't have feature PPM enabled, none of RC inputs are outputs.

[Zt3Ph3N]

Ok
my receiver Graupner GR-16 can be switched to ppm (Port 8).

So I have to connect the Receiver PPM Output to the RGV PPM Pins on the MW32
Connect the Motors to Pin 5 and 6 that were used for standard Receiver "Aux1" and "Aux2" earlier
Enable feature PPM on the FC

Is that correct?

Greetings
Stephen

[timecop]

Yes, sounds about right.
And motor order would be same as regular multiwii (or you can look at the code in mixer for exact order0

[Zt3Ph3N]

Thanks, you really helped me a lot.

Greetings
Stephen