Making changes in config.h

Post Reply
Posts: 4
Joined: Mon Nov 11, 2013 4:53 am

Making changes in config.h

Post by RobertJF_57 »

Hello, I am new to multiwiil I attempted to change things in config.h, like the min throttle and fail-safe throttle setting, but the board's behavior remains the same. I know I am successfully downloading to the board, because the fail-safe enabled when I uncommented it. Other things I have uncommented have been enabled, too. However I cannot change definitions. In Fail-safe for example, the throttle setting is too strong and the machine climbs. I have tried things like removing the "+100", or removing the "minthrottle, but the fail-safe behavior remains the same. So, what am I doing wrong?

Posts: 151
Joined: Fri Apr 20, 2012 4:22 pm

Re: Making changes in config.h

Post by fiendie »

This is the 32bit section. Try your luck here:

Post Reply