I bought a Quad from Nitroplanes.
I downloaded the software and the coinfigureator. I set the quad up via the uploader.
When I connect the quad to the comm port the port data goes green.
I click Start and a pink line appears with a blue line just above. The values are posted on the upper area.
If I move the quad, I see no variation in the oscillograph at all. The compass and the display of the quad do not change.
Am I missing some thing?
No response registering on the GUI
Re: No response registering on the GUI
Before uploading the multiwii code, you need to go into the config.h file and enable the sensors that are installed on your board. If the vendor has already done this for you then maybe it would be a good idea to double-check the existing configuration (in config.h) to confirm it matches the model they shipped you.