Hello,
I have a tecnical question, anyone now how to do a reset to a board, in this case crius se v2.5?
Because to configure the GPS, I connect and upload a lots of times the software, but now I couldnt make a upload, give me this error :
... stk500_recv(): programmer is not responding.
Probably I burn the controller, but to take the doubts, and if is possível I try to make a Hard reset, but with some bridge in hardware?
If anyone now how to do a reset, please comment.
Thank you
Crius v2.5 need Hard reset (hardware bridge... )!
Re: Crius v2.5 need Hard reset (hardware bridge... )!
If you Short the GND and RST the board will reboot.
Re: Crius v2.5 need Hard reset (hardware bridge... )!
Hello
First of all thank you, for the réply.
I try and dont work.
I attach the foto of my board.
Anyone that have some advice, please réply.
Thank you
Helder Vieira
First of all thank you, for the réply.
I try and dont work.
I attach the foto of my board.
Anyone that have some advice, please réply.
Thank you
Helder Vieira
- Attachments
-
- IMG_20161004_193017-320x307.png
- (178.24 KiB) Not downloaded yet