Hello All,
I'm trying to set up a Flip32+ Board with CPPM RX, GPS, Bluetooth and a Mobius Action Cam on a Gimbal controlled by Servo Tilt. The CPPM RX, GPS and BT configs seem to be straightforward enough, but I can't find any information confirming whether the Naze32 pinout for Servo_Tilt mode (i.e esc pins 1234 become 3456...) is the same for the Flip32+. I know settings for the Flip32 are supposed to be the same as the Naze32, except for when they aren't... Since my question involves pinout configuration, and I've seen way too many "I fried my FC using incorrect polarity etc..." comments regarding the Flip32, I would rather confirm before I connect power...
Also, most setup guides claim that you only need to connect PWR and GND pins from one ESC, but is this absolutely necessary? I'd rather not have to remove the female header pins on my other 3 ESCs in case I want to use them again...