was flying today and took a crash. replace the broken prop and now the board will not arm. I can go into the mode selection screen and see the Aux 2 input change to arm in the base flight program but the board never changes the Arm box to green, it stays red.
I have calibrated the Accelerometer and also re-flashed the firmware.
No joy.
Please help ....
NAZE 32 stopped arming!!
Re: NAZE 32 stopped arming!!
You asked this on rcgroup forum, got an answer and now its working.
For completeness:
This issue was he adjusted throttle gain on the TX so the stick command would no longer be recognized. Setting the TX gain back fixed his issue.
For completeness:
This issue was he adjusted throttle gain on the TX so the stick command would no longer be recognized. Setting the TX gain back fixed his issue.
Re: NAZE 32 stopped arming!!
Yes, I made a mistake ... Thanks for pointing it out. You did forget to tell them I thanked you as well.