Hi folks,
I've been struggling to arm the motors on my board via stick control. I've setup all the trims per required. Is there any specific sequence that needs to be followed? ie, Accelormeter has to be calibrated first etc
thanks
diso.
Cant Arm Motors on afroflight board..
-
- Posts: 244
- Joined: Sat Mar 23, 2013 12:34 am
- Location: Australia
Re: Cant Arm Motors on afroflight board..
Possibly wrong part of the forum for setup assistance.. anyhoo ===> https://www.youtube.com/watch?v=rj6IXA2hDW0
Re: Cant Arm Motors on afroflight board..
Sorry about that. Thanks for the link!
I'll probably have to hook it up to my debugger to find out whats wrong..
I'll probably have to hook it up to my debugger to find out whats wrong..
Re: Cant Arm Motors on afroflight board..
Hi,
Maybe you have still have to tune "minthrottle", "maxthrottle" and "mincommand" parameters in CLI...
Take care also of your radio mode, I mean mode 1 or 2... I took me hours until I figure out that stick configuration at the end of Naze32 manual are for mode 2... (Thanks TC )
Maybe you have still have to tune "minthrottle", "maxthrottle" and "mincommand" parameters in CLI...
Take care also of your radio mode, I mean mode 1 or 2... I took me hours until I figure out that stick configuration at the end of Naze32 manual are for mode 2... (Thanks TC )