Hey Everyone,
So last night I think I put +5v onto the motor signal pin very briefly. There was no magic smoke or anything alarming. The Board restarted itself. Now when i connect the battery to the board it doesn't power up. When i power the board via usb it works absolutely fine. So will i have blasted the micro pins which control the motor signal or have i just wiped out a voltage regulator or something else? I have ordered a new board but since I'm am studying Electronics at University and I have access to good soldering equipment at work I thought I would try and repair the board and use it for a second quad. Is there anyway to get a schematic for the board?? Any help or advice would be greatly appreciated.
Cheers guys
5+ on Signal pin Naze32 Rev 5 Damage ?
Re: 5+ on Signal pin Naze32 Rev 5 Damage ?
schematics here
https://code.google.com/p/afrodevices/downloads/detail?name=naze32_rev4.pdf&can=2&q=
should check input VCC_IN diode D4
https://code.google.com/p/afrodevices/downloads/detail?name=naze32_rev4.pdf&can=2&q=
should check input VCC_IN diode D4
-
- Posts: 2
- Joined: Thu May 14, 2015 7:33 pm
Re: 5+ on Signal pin Naze32 Rev 5 Damage ?
Nice one thank you. Just got my new board. Plugged in 1 esc and my battery and the micro went up in smoke! Grrrr company have offer a replacement though