Hi.
I m trying to build a Bicopter and im facing this problem..
what ever i do the roll is upside down.
What im doing wrong ???
ROLL up side down
- NikTheGreek
- Posts: 348
- Joined: Thu Dec 08, 2011 4:17 pm
- Location: Greece
- Contact:
-
- Posts: 24
- Joined: Mon Nov 14, 2011 2:05 pm
- Location: Sheffield, UK
- Contact:
Re: ROLL up side down
I think the first step would be to work out if it's software or hardware.
What shield / sensors are you using?
Does the roll react correctly other than being upside down?
What shield / sensors are you using?
Does the roll react correctly other than being upside down?
Re: ROLL up side down
Did you mount the sensors right way up?
-
- Posts: 24
- Joined: Mon Nov 14, 2011 2:05 pm
- Location: Sheffield, UK
- Contact:
Re: ROLL up side down
I reeealy wanted to ask that but was too scared of an angry bicopter builder berating me for asking silly questions :p
- NikTheGreek
- Posts: 348
- Joined: Thu Dec 08, 2011 4:17 pm
- Location: Greece
- Contact:
Re: ROLL up side down
Ηe he..
all posible combinations of WiiMotion+ and Nunchuck was tested before my post...
Anyway..i found the problem..
somehow the nunchuck was not connected properly with WMP and caused this...
i dont know what exactly ... maybe a short circuit..maybe a bad solder..i m not sure
And now Question No2
How can i adjust my sensors in order to take the right readings in GUI ??
Below a pic with the current status
Thnx in advance
all posible combinations of WiiMotion+ and Nunchuck was tested before my post...
Anyway..i found the problem..
somehow the nunchuck was not connected properly with WMP and caused this...
i dont know what exactly ... maybe a short circuit..maybe a bad solder..i m not sure
And now Question No2
How can i adjust my sensors in order to take the right readings in GUI ??
Below a pic with the current status
Thnx in advance
Re: ROLL up side down
Press calib_acc button and wait untill z shows around 200.
Dont move it during the calib..
Dont move it during the calib..
- NikTheGreek
- Posts: 348
- Joined: Thu Dec 08, 2011 4:17 pm
- Location: Greece
- Contact:
Re: ROLL up side down
PatrikE wrote:Press calib_acc button and wait untill z shows around 200.
Dont move it during the calib..
Thnx !!!
Stay Tuned !!!
Next question in a while !!!