Getting started with old board. Help needed

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
magnusl
Posts: 1
Joined: Tue Aug 17, 2021 9:26 am

Getting started with old board. Help needed

Post by magnusl »

I have an old Hextronik "MWC_328p with FTDI/DSM2 port".
I have tried to config the latest firmware i could fine and run the Processing GUI but without much luck. I can compile the code and upload it to the controller. A blue LED blinks, but the config GUI does not seem to communicate with the board.

Can anybody link to a tutorial or something that can get me started?

Any help much appreciated!

/Magnus

PatrikE
Posts: 1976
Joined: Tue Apr 12, 2011 6:35 pm
Location: Sweden
Contact:

Re: Getting started with old board. Help needed

Post by PatrikE »

Make sure the Baudrates is correct setup.
Normally 115200.
Test to load some other sketch to verify that you can get it to work with Arduino Serial monitor.

/Patrik

Post Reply