I have an old Hextronik "MWC_328p with FTDI/DSM2 port".
I have tried to config the latest firmware i could fine and run the Processing GUI but without much luck. I can compile the code and upload it to the controller. A blue LED blinks, but the config GUI does not seem to communicate with the board.
Can anybody link to a tutorial or something that can get me started?
Any help much appreciated!
/Magnus
Getting started with old board. Help needed
Re: Getting started with old board. Help needed
Make sure the Baudrates is correct setup.
Normally 115200.
Test to load some other sketch to verify that you can get it to work with Arduino Serial monitor.
/Patrik
Normally 115200.
Test to load some other sketch to verify that you can get it to work with Arduino Serial monitor.
/Patrik