Greetings all
I inherited this old, but workable drone from a friend.
I'm trying to put MultiWii 2.4 on there, but having some issues.
For starters, which board should I select? All the guides are for older versions of the Arduino GUI.
A few 'work' - as in they program, and the board seems to boot - but at some point I lost serial comms.
The Arduino GUI can use the serial port fine to reprogram the board, but I can NOT get MultiWiiConf to connect again. (It connected at first, before I updated the sketch).
Using Win 10, Arduino 1.8.2, MultiWii 2.4. Board has at AtMega 328P on it.
At the moment I'm powering it just off the FTDI cable... seemed to work ok at first.
Help setting up CRIUS MultiWii SE v0.2 - comms issues
Re: Help setting up CRIUS MultiWii SE v0.2 - comms issues
Never mind, sorted it ... started with a fresh config.h and it works fine now. Something in there must have been messing up comms somehow!!