Help setting up CRIUS MultiWii SE v0.2 - comms issues

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
balefire
Posts: 3
Joined: Sun Jun 07, 2020 8:55 am

Help setting up CRIUS MultiWii SE v0.2 - comms issues

Post by balefire »

Greetings all
I inherited this old, but workable drone from a friend.
I'm trying to put MultiWii 2.4 on there, but having some issues.
For starters, which board should I select? All the guides are for older versions of the Arduino GUI.
A few 'work' - as in they program, and the board seems to boot - but at some point I lost serial comms.
The Arduino GUI can use the serial port fine to reprogram the board, but I can NOT get MultiWiiConf to connect again. (It connected at first, before I updated the sketch).
Using Win 10, Arduino 1.8.2, MultiWii 2.4. Board has at AtMega 328P on it.
At the moment I'm powering it just off the FTDI cable... seemed to work ok at first.

balefire
Posts: 3
Joined: Sun Jun 07, 2020 8:55 am

Re: Help setting up CRIUS MultiWii SE v0.2 - comms issues

Post by balefire »

Never mind, sorted it ... started with a fresh config.h and it works fine now. Something in there must have been messing up comms somehow!!

Post Reply