Issue D4/Roll - NanoWii and QuadX

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
jorustyron
Posts: 2
Joined: Wed Aug 28, 2019 4:23 pm

Issue D4/Roll - NanoWii and QuadX

Post by jorustyron »

Good day,

When testing the MultiWii program, I don't have data coming from the pin D4 (ROLL). Although everything else works fine, I can read the PITCH, YAW, THROTTLE, etc.

My setup is:
- RC: Futaba T14SG
- Receiver: Futaba R7008SB
- Micro-controller: Arduino Nano (official)
- Drone: QuadX
- Channel 1 (ROLL) is connected to pin D4

Tests I've made:
- Downloading the program from the official source, not customised: working well, as expected
- Changing the copper wire: working well, as expected
- Plugging a servo on the Channel 1 (ROLL) receiver: working well, as expected
- Connecting the receiver's ROLL (channel 1) to pin D2 of the Arduino Nano: working well, as expected
- Connecting the receiver's ROLL (channel 1) to pin D4 of the Arduino Nano: not working
- Connecting the receiver's THROTTLE (channel 4) to pin D2 of the Arduino Nano: working well, as expected
- Connecting the receiver's THROTTLE (channel 4) to pin D4 of the Arduino Nano: not working
- Wiring an LED on pin D4 (ROLL) and run a blink program: working well, as expected

Do you guys have any ideas where that can come from?
Anyone is in touch with one of the programmers?

Thanks for your answers

Regards,
JorusTyron

Post Reply