I'm so new at multiwii and a terrible Arduino programmer! sorry!
I am trying to set up multiwii for a singlecopter for a micro brushed helicopter.
I need to use servos for the cyclics but change the outputs for throttle and yaw to pwm for motor control via fet's instead of servos. I'm at a loss as to figure out how to do that, exactly. Can someone help me, please?
How to change servo output to pwm/fet motor control
-
- Posts: 9
- Joined: Wed Apr 12, 2017 8:19 pm
-
- Posts: 9
- Joined: Wed Apr 12, 2017 8:19 pm
Re: How to change servo output to pwm/fet motor control
291 views and *no one has anything to say?
Re: How to change servo output to pwm/fet motor control
OK, I'll answer then.... since I've looked at your thread
Sorry, but I haven't clue on how to solve your problem
Sorry, but I haven't clue on how to solve your problem
Re: How to change servo output to pwm/fet motor control
A tip can be to search for "brushed" in config.h
-
- Posts: 9
- Joined: Wed Apr 12, 2017 8:19 pm
Re: How to change servo output to pwm/fet motor control
PatrikE wrote:A tip can be to search for "brushed" in config.h
Thank you! I will check that out.
Coincidentally, I kinda gave up on using multiwii for this application, broke down and grabbed a skyline32 to use cleanflight.