I have the hobbyking V2.5 board and with 20A simonk escs.
I have uploaded both multiwii v2.4 and v2.3 and both give the same problem.
When I arm the board it runs the motors at their minimum and then when I increase
throttle theres a 10 degree deadzone on my stick and then it goes to half power at the
next interval. I have also tried setting the min throttle to the original and the
simonk value in both versions of multiwii.
Any help would be great, thank you.
Motors Spin When Armed
Re: Motors Spin When Armed
Uncomment the following in config.h
Code: Select all
/**************************************************************************************/
/*********************** motor, servo and other presets ***********************/
/**************************************************************************************/
/* motors will not spin when the throttle command is in low position
this is an alternative method to stop immediately the motors */
//#define MOTOR_STOP
-
- Posts: 2
- Joined: Thu Jan 07, 2016 2:12 pm
Re: Motors Spin When Armed
Thank you very much Leo!