MULTIWII QUADCOPTER without Hobbyking Transmitter & Receiver

[PA3040]

Dear All,


My CRIUS pro v1.0 is reading properly with MultiWiiConf GUI

My question is .....Can I able to turn on and off my quadcopter motors using MultiWiiConf GUI ( without Hobbyking Transmitter & Receiver )


is it possible to run the rotors by changing the value in the area showing in the picture . I did it but no any turns from the rotors

Please advice

Thanks in advance

[LutzB]

If you just want to test the motors you can use the dynbalance definition in the config. Compile and upload the sketch. When you now connect with MultiWiiConf you will get another tab where you can play with motor values. But with this sketch you are not able to fly! You will have to upload again with dynbalance commented.

[PA3040]

Thanks LutzB

I already change the sketch #define MINCOMMAND 1400 that changed the minimum throttle level from 1000 to 1400. It was succeed and rotors are spinning but when i remove the power and re connected, then it does dot run and I kept it few minutes power off and reconnected then it is working and so on
please advice
thanks in advance