we tried to access the readings from multiwii controller se v2.5 from uart port,for that we used usb to serial converter(max 232).
It worked properly with multiwiigui 2.2 properly and we had calibrated the quad(x),and we got the parameters too.
But problem came here ,when we did the same on the next day ,the multiwii gui is not connecting instead it gives the error"please check if u have selected the right com port".For checking weather the multiwii board is working or not ,we had uplaoded a sketch to return some names serially,but even through that also we are not getting any data through max 232 serial(by seeing in serial monitor). can any one help me regarding this ...
multiwii se v2.5 not connecting to com port through gui
-
- Posts: 234
- Joined: Wed Dec 24, 2014 1:20 am
- Location: ......
Re: multiwii se v2.5 not connecting to com port through gui
.
Last edited by FengShuiDrone on Fri Aug 07, 2015 1:28 am, edited 1 time in total.
Re: multiwii se v2.5 not connecting to com port through gui
Thank u Mr. fengShuiDrone for reply,i had rechecked everything,in config.h baud rate is 115200,even in the gui also i had set it at same rate,even com port too..,even then i am unable connect to gui...
-
- Posts: 234
- Joined: Wed Dec 24, 2014 1:20 am
- Location: ......
Re: multiwii se v2.5 not connecting to com port through gui
.
Last edited by FengShuiDrone on Fri Aug 07, 2015 1:29 am, edited 1 time in total.
Re: multiwii se v2.5 not connecting to com port through gui
FengShuiDrone wrote:Are you hooking RX to TX and TX to RX?
yeah ,,i also tried reverse ,connecting rx to rx and tx to tx alsoo...