setting up via bluetooth only

[handsomejackuk]

Hi i have multiwii vers 2.2 running on my arduino nano 328 d.i.y. controller the flight controller is built in to the frame and not easy access to the usb lead... now i know there are some things i can setup via multiwii.conf, and multiwii ez-gui. like all the pids, and flight modes etc... but is there any other way to access commands like motor stop, min throttle, failsafe throttle without having to plug in the usb lead.. my blue tooth works great..

can i send commands to the board directly to alter these features..

or can i upload firmware to the board via the bluetooth ?

please advise...

i think i have been spoilt by naze32 and cleanflight...

[Arakon]

No. You need a direct connection to flash.