Hi all, i used horizon flight mode most of the time so far. For a specific behavior i want to use angle mode. Some questions:
1) is it correct, that in angle mode, the quadrocopter never goes over a specific angle (compared to level/horizon) - and regardless of the sticks - it should never "flip" ?
2) if 1 - where to set this maximum angle?
3) if not 1 - what is the difference to horizon mode?
Thanks!
where to set max. angle in "angle mode"
-
- Posts: 234
- Joined: Wed Dec 24, 2014 1:20 am
- Location: ......
Re: where to set max. angle in "angle mode"
.
Last edited by FengShuiDrone on Sat Aug 08, 2015 12:26 am, edited 1 time in total.
-
- Posts: 1630
- Joined: Wed Jan 19, 2011 9:07 pm
Re: where to set max. angle in "angle mode"
Hi,
1) 2) yes, in angle mode, the max possible angle is 50deg if you use the recommanded TX range [1000-2000]
it is adjustable in the code, but not in a gui or via config settings.
3) horizon mode acts as ACRO mode at full stick deviation. (middle stick = ANGLE style / full stick = ACRO style / between = a proportion of the modes)
1) 2) yes, in angle mode, the max possible angle is 50deg if you use the recommanded TX range [1000-2000]
it is adjustable in the code, but not in a gui or via config settings.
3) horizon mode acts as ACRO mode at full stick deviation. (middle stick = ANGLE style / full stick = ACRO style / between = a proportion of the modes)
loeten wrote:Hi all, i used horizon flight mode most of the time so far. For a specific behavior i want to use angle mode. Some questions:
1) is it correct, that in angle mode, the quadrocopter never goes over a specific angle (compared to level/horizon) - and regardless of the sticks - it should never "flip" ?
2) if 1 - where to set this maximum angle?
3) if not 1 - what is the difference to horizon mode?
Thanks!