Hi,
current setup arduino nano board running maultiwii 2.2
i need two auxiliary rc inputs 1 to arm disarm board, and the other aux receiver to switch flight modes...
I could use yaw on the stick to arm but prefer a physical switch...
is it still possible to have landing lights and led flasher with this config ?
I am trynng to cover all avenues and would like some bright ilumination when quad is disarmed i.e. failsafe so i can find it if it gets lost
i have rc auxpin8 enabled in aux 2 pin section to enable my second receive auxilliary input, but whenever i enable landing lights on port c1 it kicks out my auxiliary channel....
is there any other way to do this...
aux1 and aux2 and landing lights, and flasher...Possible ?
-
- Posts: 97
- Joined: Mon Sep 08, 2014 12:25 am