Initialisation problem with 328P controller
Posted: Tue Dec 11, 2012 5:11 pm
Hello All,
I have a strange problem with a MultiWii 328P controller which I purchased from hobbyking(MultiWii 2.1 loaded). Every time I connect the battery to the ESCs, the controller seems unable to initialize. Sometimes I get no blue led at all, sometimes only very short after which I cannot arm the board. Most of the time I have to disconnect the battery about 3 times before the board correctly initializes and I'm able to arm. Once I can arm the board everything works just fine, flying as well. I tried messing around with the mincommand, minthrottle and maxthrottle parameters but that seems not to work at all. Does somebody have any idea what could cause this strange behavior?
I'm about to try MultiWii 2.0 to see if that works better.
Thanks!
Regards,
Kevin.
I have a strange problem with a MultiWii 328P controller which I purchased from hobbyking(MultiWii 2.1 loaded). Every time I connect the battery to the ESCs, the controller seems unable to initialize. Sometimes I get no blue led at all, sometimes only very short after which I cannot arm the board. Most of the time I have to disconnect the battery about 3 times before the board correctly initializes and I'm able to arm. Once I can arm the board everything works just fine, flying as well. I tried messing around with the mincommand, minthrottle and maxthrottle parameters but that seems not to work at all. Does somebody have any idea what could cause this strange behavior?
I'm about to try MultiWii 2.0 to see if that works better.
Thanks!
Regards,
Kevin.