TX/RX problem

[Gus]

Hi,
I bought a NanoWii 1.0 as control board for a quadrotor platform. I have programed successfully the board with de QuadP configuration, and the MultiWiiConf_2_1 works to estimate the attitude of the quadrotor, but when I tilt the joystick of my TX any change appear in the GUI (throttle, pitch, roll, yaw... are freezed on 986).

As a consequence when we try to pilot the throttle thanks to the radio system, it does not work.

Ihave the following devices:
- motor: turnigy T1811-3800kV
- ESC: turnigy Plush 6A
- a spektrum receiver: AR6115e (6ch 2048)
- a radio command: spektrum DX5e
- a battery Turnigy 2s: 850mAh

To arm the ESC I try to tilt the yaw stick right while having the throttle stick in minimum position but it doesn't work... But I can control the throttle if I connect my Receiver directly to the ESC without troubles.

Have you any idea what I ame doing wrong?

Thanks

Gus

[scrat]

Your sticks must move from 1000 to 2000 and center at 1500. Can you set endpoints on your Tx?