Page 1 of 1
rigth stick for the rigth activates motor?
Posted: Fri Jun 29, 2012 3:19 am
by lucaszanella
I'm reading the values in the GUI and all transmitters connections are rigth, but when I move the rigth stick of my transmitter to the rigth position the motors activate
Re: rigth stick for the rigth activates motor?
Posted: Fri Jun 29, 2012 4:25 am
by PatrikE
It's selectable in Config.
Code: Select all
/******************************** ARM/DISARM *********************************/
/* optionally disable stick combinations to arm/disarm the motors.
* In most cases one of the two options to arm/disarm via TX stick is sufficient */
#define ALLOW_ARM_DISARM_VIA_TX_YAW
//#define ALLOW_ARM_DISARM_VIA_TX_ROLL