Motor not responding to my PPM input

This forum is dedicated to all issues and questions related to your individual setups and configurations

Motor not responding to my PPM input

Postby ys2664 » Fri May 31, 2019 10:04 am

I have successfully connected my fs-i6 RC transmitter to my flight control, which contains Arduino nano and MPU6050.
And when I push the sticks, the numbers on MultiWii GUI do respond, but the motors won't!!!!
Then I checked the output of the pins that send PWM signal to ESCs, they are PWM signals, but the duty cycle never changes no matter how I push the sticks.
There must be something wrong with the configuration I believe.
I just don't know where it is. If this gets solved, the drone can take off in a second. Please help me, thank you all.
ys2664
 
Posts: 1
Joined: Fri May 31, 2019 9:50 am

Return to Getting Started - MultiWii config and setup

Who is online

Users browsing this forum: No registered users and 1 guest

cron