How to change servo output to pwm/fet motor control

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
interestingfellow
Posts: 9
Joined: Wed Apr 12, 2017 8:19 pm

How to change servo output to pwm/fet motor control

Post by interestingfellow »

I'm so new at multiwii and a terrible Arduino programmer! sorry!
I am trying to set up multiwii for a singlecopter for a micro brushed helicopter.
I need to use servos for the cyclics but change the outputs for throttle and yaw to pwm for motor control via fet's instead of servos. I'm at a loss as to figure out how to do that, exactly. Can someone help me, please?

interestingfellow
Posts: 9
Joined: Wed Apr 12, 2017 8:19 pm

Re: How to change servo output to pwm/fet motor control

Post by interestingfellow »

291 views and *no one has anything to say?

User avatar
Leo
Posts: 372
Joined: Wed Sep 17, 2014 7:01 am
Location: Germany
Contact:

Re: How to change servo output to pwm/fet motor control

Post by Leo »

OK, I'll answer then.... since I've looked at your thread :)

Sorry, but I haven't clue on how to solve your problem :|

PatrikE
Posts: 1976
Joined: Tue Apr 12, 2011 6:35 pm
Location: Sweden
Contact:

Re: How to change servo output to pwm/fet motor control

Post by PatrikE »

A tip can be to search for "brushed" in config.h

interestingfellow
Posts: 9
Joined: Wed Apr 12, 2017 8:19 pm

Re: How to change servo output to pwm/fet motor control

Post by interestingfellow »

PatrikE wrote:A tip can be to search for "brushed" in config.h


Thank you! I will check that out.

Coincidentally, I kinda gave up on using multiwii for this application, broke down and grabbed a skyline32 to use cleanflight.

Post Reply