bootloader problem?

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
multiwire
Posts: 1
Joined: Tue Mar 17, 2015 5:21 am

bootloader problem?

Post by multiwire »

Recently picked up a flip ez and wanted to configure/check on baseflight, but the serial port opens and says "no configuration received, serial port closed." When I try to flash Baseflight FW it says “no response from the bootloader, programming failed.”

It will connect to MultiWii Conf. but I am not familiar with the Arduino IDE side where it seems most of the changes need to be set. It may have also had trouble connecting there and I'm not sure which board it is supposed to be set on in the Tool tab.

Any help appreciated. This is a new board and does arm and spin up, but there a few things I need to fix and would like to check on.

waltr
Posts: 733
Joined: Wed Jan 22, 2014 3:21 pm
Location: Near Philadelphia, Pennsyvania, USA

Re: bootloader problem?

Post by waltr »

BaseFlight does NOT run on 8-bit Atmel processors.
It will only run MultiWii so go read the MultiWii WIKI.

Post Reply